Redondo Installation Instructions

LOW ENERGY FLUORESCENT LIGHTING
¨ FOR 14", USE ONE 22 WATT AND ONE 32 WATT FLUORESCENT CIRCLINE LAMP.

BEFORE YOU START:

IMPORTANT
FIXTURE’S GROUND WIRE MUST BE CONNECTED FOR LAMP TO OPERATE.

CAUTION: IF POWER SUPPLY WIRES OR CORDS ARE LOCATED WITHIN THREE INCHES OF BALLAST, USE WIRE OR CORD SUITABLE FOR AT LEAST 90°C (194°F). TO PREVENT RISK OF FIRE, DO NOT USE FIXTURE ON DIMMING CIRCUITS.

MOUNTING INSTRUCTIONS

1. Remove fixture from box.

2. Lay lamp on it’s back (metal surface down).

3. Remove plastic lens by gently lifting.

4. Remove bulbs.

5. Remove mounting hardware from inside of box.

6. Assemble spring clips to fixture, by positioning clips on the wide end of the “T”-slots with the two downward turned legs of the clips extending through the fixture. Pull the clips away from the fixture center until the clips snap into the “T”-slots. (See Illustration 1)

7. Secure fixture’s mounting screws (only screwing in halfway) to “J-box”. (See Illustration 2)

8. Using wirenuts connect ground wire (green) from fixture to ground wire from “J-box”. (See Illustration 3)

9. Using wirenuts connect black wire from fixture to black wire from “J-box”, and repeat the same process with the white wires. (See Illustration 3)

10. Attach fixture to mounting screws, turn fixture clockwise, and tighten screws. (See Illustration 4)

11. Plug large circline lamp first. Check the ballast label to determine which lamp plug to use. Place lamp over spring clips, and gently push over the third clip. Repeat this procedure for the second (inner) circline bulb. (See Illustrations 5 & 6)

12. To install acrylic plastic lens, hold lens up to fixture, and fasten small screws securely to fixture.

13. Restore power at fuse box or circuit breaker box.

Hampton Bay Instructions for 14" Redondo

Copyright © 2000 CompanyLongName