17" Slimline Installation Instructions

LOW ENERGY FLUORESCENT LIGHTING
¨ FOR 17", USE ONE 32 WATT FLUORESCENT CIRCLINE LAMP.

BEFORE YOU START:

Power On-Off.gif (6866 bytes)

IMPORTANT
FIXTURE’S GROUND WIRE MUST BE CONNECTED FOR LAMP TO OPERATE.

CAUTION: IF POWER SUPPLY WIRES OR CORDS ARE LOCATED WITHIN THREE INCHES OF BALLAST, USE WIRE OR CORD SUITABLE FOR AT LEAST 90°C (194°F). TO PREVENT RISK OF FIRE, DO NOT USE FIXTURE ON DIMMING CIRCUITS.

MOUNTING INSTRUCTIONS

  1. Remove fixture from box.

  2. Remove plastic lens by depressing. Gently push lens to one side exposing edge. Lift edge of lens to remove.

  3. Remove bulbs from spring clips during installation. (Illustration #1)

  4. Remove socket which is secured to bulb. (Illustration #2)

  5. Remove mounting hardware from inside of box. Follow Illustration #3 to mount and wire fixture.

  6. Attach ground wire from fixture to fixture mounting screw. (Illustrations #3,a,b)

  7. Reinstall bulb into fixture. (Illustration #4)

  8. Flex lens and slide under lip of fixture to reinstall. (Illustration #5)

Line.gif (230 bytes)

13-Clip.gif (5151 bytes)

17Strap.gif (15680 bytes)

Mounting Lamp.gif (11910 bytes)

Lens Cover Instl.gif (5658 bytes)

 

Hampton Bay Instructions for 17" Slimline

17 Inch Instrcn-1.JPG (87006 bytes)
Slimline Instrcn-1.JPG (95317 bytes)

Slimline Instrcn-2.JPG (69421 bytes)
17 Inch Instrcn-2.JPG (101272 bytes)

17 Inch Instrcn-3.JPG (93064 bytes)
Hampton Bay Warranty.JPG (153313 bytes)
Hamptn Bay Slug.gif (4476 bytes)

WB01337_.gif (904 bytes)
BACK

WB01338_.gif (869 bytes)
HOME
 
Copyright © 2000 CompanyLongName